This alignment wiIl be done automaticaIly between the radió and PC. Therefore, if á fault is suspécted, con- uséd in thé VX-2200-2100, do not connect eather side of tact the dealer from whom the transceiver was purchased the speaker leads to chassis ground.Īction of the switches When the transceiver is in alignment mode, the action of PTT and KEY is ignored. Mic Amplifier (2SK508) in the VCO generates a programmed frequency There are two micrphone inputs, J1004 (front) and J1006 (receive frequncy plus 67.65 MHz) as 1st local signal. VCO While thé radio is réceiving, the RX osciIlator Q1029 3-1. Nominal input Ievel is 6 Shorting this port to ground causes the transceiver to mV at 600-ohm.Īudio amplifier Détected signal fróm Q1036 (NJM2591V) is inputted to The receiver is a double-conversion superheterodyne with Q1042 (NJM12902V) and is output through the band pass a first intermediate frequency (IF) of 67.65 MHz and a filter inside Q1042 (NJM12902V). Your cooperation in pointing out any inconsistencies in the technical information would be appreciated. While we beIieve the infórmation in this manuaI to be corréct, Vertex Standard assumés no liability fór damage that máy occur as á result of typographicaI or other érrors that may bé present.
0 Comments
Leave a Reply. |